Ferrite Magnet
ABUIABACGAAgn7r31QUoz6DKtAQw2AQ4kAM

Since the 1950s, hard ferrite (ceramic) magnets have been widely applied because of low cost, good magnetic properties and excellent environmental stability. Depending on the base materials, there are Barium Ferrite and Strontium Ferrite with higher coercive. But in recent years Barium Ferrite have been abandoned for environmental and health reasons. After preliminary inspection, the raw materials (mainly iron oxide, strontium carbonate) are weighed, blended, pre-sintered and milled to fine powders with hexagonal crystals. For isotropic magnets, the pre-materials are milled to powders and then pressed. For anisotropic magnets there are two procedures in the production, dry press and wet press. Firstly, the raw materials are dried and then pressed in a magnetic field. Secondly, the raw materials are wet pressed under the influence of a magnetic field, then followed by sintering, finishing cleaning and magnetization. Finally the surface can be machined, marked, magnetized or coated according to customers' requirements.

标签模块
Introduction
Physical
Flow Chart
Tolerance
Old Production Line
ABUIABACGAAg39-31QUo6qvzpAYwgAY4tAE
ABUIABACGAAg4t-31QUow5L_uQUwgAY4tAE
New Production Line
ABUIABACGAAgksj31QUo2d28_AYwnAo45go
ABUIABACGAAglcj31QUo2OvOMzCcCjjWBA
ABUIABACGAAgjcj31QUo_KfmYzCcCjiICA
Production Process
ABUIABACGAAggcv31QUoopq04AEw7gU47gU
Physical properties of Ferrite Magnet
ABUIABACGAAg3NT31QUo373WgQEwrgg4zwU
Temperature of Ferrite Magnet
ABUIABACGAAg2NT31QUopOfJpQEwoQg4qwE
ABUIABACGAAg3Zj_1QUozNbl_gUwoQM4Mg
© 2018 NINGBO ZHONGYUAN MAGNET Co., Ltd. All rights reserved.
This website uses NBZY Magnet Build
Mobile version